Before you go live · Setup

Get the event ready before anyone is in the room.

Setup is an operator-facing configuration assistant. It works with your team before the event — not during it.

Setup is deliberately separate from Engage, Answer and Protect. Those three operate during a live event. Setup does not run in the room and cannot act on an audience.
What Setup helps with

The preparation that decides how the event goes.

Most live-event problems are configuration problems that only became visible under pressure. Setup moves that work forward, into a moment where getting it wrong costs nothing.

Configure an event
Create the event, choose which surfaces are in use, and set how participants will join.
Prepare agent settings
Set each agent to Off, Assist or Auto for this event, with the reasoning recorded alongside it. How the modes work
Prepare event knowledge
Assemble the FAQs, policies, documents and speaker material Answer is allowed to draw on — and nothing else. Event knowledge sources
Define event tone and rules
State in plain language what this event does not discuss, and how contributions should be handled. These become the rules Protect applies. Event-specific rules
Get ready to go live
Run the event in Test, see what Answer produces from your sources, check what the Wall looks like, and confirm the moderation rules behave the way you expected.
Recurring events

Set it up properly once.

A quarterly all-hands is the same event four times a year with different content. The rules, the tone, the agent configuration and most of the knowledge carry over.

Setup is where that becomes reusable, so the fourth event takes minutes to prepare rather than repeating the first event’s work.

  • Carry configuration forward to the next event
  • Keep event rules consistent across a programme
  • Update event knowledge without rebuilding the event
  • Compare like with like in Report, event to event

Template and reuse behaviour